![]() Essentially what these are are profiles for specific controllers, so when you plug in controller A, it recognizes what type of controller it is and uses the controls you specifically setup for it, then you can plugin controller B, it recognizes what type of controller it is and uses the controls you specifically setup for it, and so on. Now whenever you plug in each controller it should use whatever you've specified for each controller individually.īased on what you're describing, what you need isn't per-core/platform remaps, you just need to setup controller autoconfigs. Now unplug that controller, plug in the next controller, and repeat the above steps. Plug in one controller, go to Settings > Input, make sure "Autoconfig Enable" is set to on, then go down to Input User 1 Binds, use "User 1 Bind All" and then select "User 1 Save Autoconfig". You need to set each of them up one at a time with autoconfigs. I had this happen to me when I first tried to use a USB SNES pad. What can happen if you don't setup autoconfigs for each different type of controller is that it doesn't understand what you want to do with it and just uses a default (like an Xbox controller layout) even if the specific controller you've plugged in doesn't support the same buttons/sticks/etc. You know how when you plug in a controller with RA running or whenever you start it up how it says "Controller blahblah connected"? That's where it's indicating that a specific type of controller is connected and which port it's going to use it for. It'd be nice to be able to plug in my Xbox One controller and play SNES games and then plug in the SNES controller and play games too without having to always rebind the keys. Is this possible?īonus Question: What's the best way to exit out of emulators and games when you're using a controller that doesn't have Start & Select? Should I just get something like this: ie=UTF8&qid=1532620725&sr=1-10&keywords=programmable+button+pcīased on what you're describing, what you need isn't per-core/platform remaps, you just need to setup controller autoconfigs. Is there a way to save the input config profiles on a controller basis, instead of platform, or core basis? How can I save a different default configuration for each specific platform? Once I plugged in these retro controllers, I was having serious issues because of where I mapped my retroarch hotkeys. All of my previous controls have been mapped to my two Xbox One controllers. I recently purchased a bunch of retro controllers for my BigBox setup.Įxcited to try them out, I plugged them into my PC and all hell broke loose with retroarch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |